Opties

Surface Pro 4 boards with power problems. Anyone have experience?

I have a few bad boards that I am trying to refurb. Wondering if there are any techs out there that have experience with component level repair on these SP4s.

I have already fixed a few.

Had one with the known bad 0ohm resistor near CPU.

Had one with the known bad diode preventing it from running from battery.

Also had a few with 3.3v line shorted to ground. Two of them were the ITE bga chip shorted internally and another was a tiny capacitor on the backside of the board.

Now I am left with three boards that won't turn on but don't share any of the above faults.

Since I have working boards to compare to I have been probing around in diode mode. I found some difference between good and bad boards but don't really know what to make of it.

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0

1 Opmerking:

I don’t have any experience with refurbing component level issues but I am in need of a guide if you could be of any assistance. I believe I have a bad motherboard and do not understand the safe way to go about finding if the 0 Ohm resistor has gone bad. Could I use a multimeter to check for the resistance or could that potentially damage the board?

door

Voeg een opmerking toe