Repareer je spullen Gemeenschap Winkel

Model A1318 / 32 or 64 GB capacity

299 Vragen Bekijk alle

Opties

battery connection plate came off mainboard

Hi all, Im new here and would like some advice.

I have just started fixing ipod touches and selling them on, I have come across a problem, when de-soldering a battery on a 32gb 3rd gen the centre plate came away from the mainboard! I have tried to get a fixing to the remaining thread but that also came away! is there any way of bypassing the centre plate and say soldering the centre battery terminal to a pin on the inside with a fine sleeved wire? it sounds logical unless the mainboard changes the current through resistors???!!!??? would really appreciate any help.

dan

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score -1
1 Opmerking

I had the center pin come off on me also, but it pulled the copper strip away from the motherboard and broke. Like Dan asked is there another terminal that a small wire can be soldered to bypass that center terminal?

door

Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

This is simple, the pad the lifted off you need to put back in place. If you have rosin flux in a liquid form use that cause once it dries it becomes sticky and will hold it in place for a little while. Then solder the two outside connections of the battery first and then lastly solder the center connection. This will keep the connection held down and the flux will conduct electricity through itself. I have done it many times

Was dit antwoord nuttig?

Ja Nee
Score 1
Voeg een opmerking toe

Voeg je antwoord toe

dan zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 1,026