Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Vragen Bekijk alle

Opties

iPhone 6 Searching issue

Hello all.

I started having a gps issue a couple of weeks ago and ordered an antenna flex cable to correct it. While waiting for cable to arrive, service issue came up. Couldn’t connect to my cell network. I tried resetting network settings, ejecting SIM card, restarting phone, hard reset on phone.

Got the cable, replaced it, restarted phone a couple of times, and service was back, GPS came back. Problem solved. That was 2 days ago.

Yesterday, left the house, got the Searching again. Restarted the phone, got my cell network back.

Today, got searching again. Restarted the phone. Still searching. Went through everything again. Reset network settings. Pulled and put SIM back in. Restarted phone. Hard restart.

Any thoughts?

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

After you have eliminated antennae or network locks as the possible culprit, searching issues on the iPhone 6 are usually related to the baseband IC. The baseband IC is very sensitive, just like the Touch IC's on the 6 Plus; it also suffers from poor quality traces and pads.

 Go to your phone’s dialing keypad and dial *#06#. You should see the IMEI displayed.

If the IMEI is not displayed, the Baseband IC has to be reballed and two small copper traces (U1/V1) have to be rebuilt and solidified. This is commonly referred to as the “long jumper” solution. You can check out this answer (Service is "Searching" indefinitely) (by @teetopp) as it summarizes the issue really well.

Was dit antwoord nuttig?

Ja Nee
Score 1

2 opmerkingen:

When I dial #06# and press the dial button, it tells me error performing request. Unknown error.

Is this the indication that the Baseband IC has to be reballed as you indicated above?

door

You don't have to press the dial button, once you enter in the last "digit" (in this case: #) it will automatically display the IMEI. Try again without hitting the dial button. If you don't see the IMEI, then you have a baseband IC issue.

door

Voeg een opmerking toe

Voeg je antwoord toe

Peter Theodorelos zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 1

Altijd: 861