Rep: 13
2
1
See photo:
This is a connector for an Ipad Pro charging port. I am replacing this however, when I took the old one off half of this pad came off..
Can I solder to this pad with majority of it gone or do I have to run a jumper? I am just learning so please have some mercy. Thank you!
Is dit een goede vraag?
Rep: 782,4k
1,1k
893
2,3k
@smitty1510 yes you can but you better be good at it. No room for fudging and you only have one chance.
Was dit antwoord nuttig?
@oldturkey03 I need to run a jumper... No schematic or BV available for this model. Not on ZXW either... Any Ideas? How can I find out where to run the jumper?
@smitty1510 there is no way unless you have the schematic.
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 3
Altijd: 108
