Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Vragen Bekijk alle

Opties

iPhone 6 has no touch ID after a screen replacement

I recently did quite a routine repair on an iPhone 6 screen. However, after the screen was placed in and the phone powered on (yes with original home button) there was no touch ID. i then tested the sensor with the old screen to see if it was an issue with the ribbon cable behind the screen and the same error message popped up. there are no visible tears to the home button flex cable or damage to the logic board also.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

It doesn't take much to damage the Home button. If you have access to a magnifying glass or jewelers loupe, look at the flex cable within the Home button again. All it takes is a tiny tear on the edge to seal its fate.

Was dit antwoord nuttig?

Ja Nee
Score 1

1 Opmerking:

Yeah looked over it with a magnifying glass fairly sure the cable is intact

door

Voeg een opmerking toe

Voeg je antwoord toe

Felix Gilroy zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 56