Ga door naar hoofdinhoud

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Vragen Bekijk alle

LCD screen replacement part

I replaced the LCD on my iPhone 6 but the edges at the bottom around the headphone jack and speaker wont line up plush with the metal frame or bottom half of the iphone. Everywhere else is perfect and fits nice and tight, how can i fix this and why is it doing this???

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
3 opmerkingen

Is the metal iPhone housing frame damaged?

door

How do I post a picture this thing didn't show my pictur [ ] it's only at the base of the phone, like I said it's plush against the frame elsewhere.

door

Technically I've already answered my own question I guess as the frame is damaged, what I'm really trying to figure out is how can I fix it, I guess a better question would have been "how can I fix a bent rear casing?". I've found that iFixit has a bend repair tool which is pretty sweet but they don't have all models it looked like and It's a good buck for the thing which kind of sucks.

door

Voeg een opmerking toe

1 Antwoord

Het nuttigste antwoord

Can you post pictures?

Maybe your back housing/cover is bent. I would say 60% of all iPhone 6/6plus bent.

Or maybe you didn't put it back properly. The frame + metal plate maybe not go all the way inside to the base.

Was dit antwoord nuttig?

Score 2

3 opmerkingen:

It was bent I did some bending with plyers to get it where it's at now which is far better but I'm OCD when it comes to my repairs so it's just not enough it also has some dents in it so I'm assuming it could also be because of these drop damages on the phone. The gap is small so I'm mainly trying to find a way of fixing it with maybe like a glue or past or something along those lines but I don't know what would be best.

door

I think you are right. It won't fit perfectly once the phone is bent and if it has dent around the corner. Hope your new LCD has good quality. Otherwise, frame maybe separate from the screen because of bent.

door

And if the gap is small then, better leave it that way. If this is for your customer then, show them and explain them it won't be fit like before and let them use a good case that cover all edges. Or change the whole back housing.

door

Voeg een opmerking toe

Voeg je antwoord toe

Felix Robinson zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 5

Afgelopen 30 dagen: 11

Altijd: 92