Reputatie na verloop van tijd
Reputatieverdeling
Gebeurtenis | Telling | Delta |
---|---|---|
Iemand heeft jouw handleiding afgewerkt | 166 | 2000 |
Iemand vond jouw gids leuk | 131 | 1064 |
De admin heeft jouw handleiding goedgekeurd | 1 | 100 |
Bericht met een link naar jouw handleiding positief beoordeeld | 5 | 31 |
Beoordeelde een post negatief | 1 | -2 |
I purchased my Antenna Flex Cable @ Amazon and it did not have the little blue plastic and did look used but I made the change and it work’s great. Now, I did not print the pictures where the screws where named but instead I wrote the screw length on a peace of paper under the step number and I put the removed screws un the paper on top of it’s size and follow the steps on my computer screen.
Places I struggle: 1) installing the Antenna Flex Cable, it was hard to push the 4 littles connectors into places without bending the part.
2) reconnecting the volume control cable connector, I could not find the correct place but it went well after I pulled it down just a bit
3) reconnecting the antenna cable connector (step 23)
4) setting back the standoff screw, I think iFixit have a special screwdriver for that, next time I will get it
Thanks for the great repair guide you saved me lots of $$$
Ying-yang sing? I can't see it...
Are you talking about the ends of the cable ?
If it is the case, just strip a little bit no longer than 3/16" of an inch ( like 3mm ) you have to make sure it is not too long; you can see at the step 8, there is no room on the other side of the board.
And heat it to apply soldering on it so it looks like the picture, it is easy to insert and it weld solidly.
@Kim
My guess is to take a look at the step 29 to make sure the contacts are placed properly
@ Nicole.
The picture shows the parts from step 4 (third picture) and 25.
I am sorry to tell you, you will have to open the phone again.
Good luck.
You wrote the details the way I should have. but there is no point in just repeating all you said, Thanks ;-)