If it's broke I can usually fix it.
- Windows 8 & 8.1, Windows Server 2012, Windows 7, Windows Vista, Windows XP
- Legacy Versions of Windows (95/98/ME/NT 4.0)
- Mac OS 9 and Mac OS X
- Intel & AMD Based Desktops, Laptops, Mobile Devices including Apple iPad and iPhone
- Wireless Router Technology including Linksys, Netgear, D-Link, Mobile Hotspots & Apple Airport
- Printer Setup (USB/Wireless)
- Email software including: (Outlook 2003 / 2007 / 2010 / 2013) Outlook Express, Microsoft Exchange
- Browser software including: (Internet Explorer versions 6 - 11), Firefox, Chrome, & Safari
- Backup software including: Windows 7 Backup, Norton Ghost, Macrium Reflect & Acronis True Image
- Windows system image deployment / Windows recovery
- Dell, HP & Intel OEM adapter WiFi Software use and configurations
- Adware / Spyware / Malware / Virus Prevention and Removal software, including McAfee, Norton, TrendMicro, avast!, & Microsoft Security Essentials
- TCP/IP, DNS, DHCP, PPPoE, NAT Configurations & Static IP Routing using IPv4 / IPv6
- Wireless 802.11 a/b/g /n /ac standards and WEP, WPA/WPA2 (TKIP / AES) Encryption
- Firewall Implementation and Configuration as well as Port Forwarding, DMZ and UPnP
- Network Access Storage devices (NAS) as well as Cloud Computing
- Ping, Trace route, Ipconfig & netsh commands to locate & resolve connectivity issues
- Data Closets, Ethernet Switches & Whole Home Ethernet
- CAT5, CAT5E & CAT6 Ethernet
- DOCSIS 2.0 & 3.0 Cable Modems and EMTA’s
- Modem & Router Bridge Mode Configurations
- Wireless Repeaters, Range Extenders & Various Ethernet network bridges
- Component level troubleshooting
- AC Wiring
- DC Wiring
- Home Audio/Video
- Security Systems
- Troubleshooting wiring issues
- Troubleshooting and testing sensors
- Car Alarm Installation
- Remote Start Installation
- Fuel Injection service
Handleidingen waar ik aan meegewerkt heb
Antwoord op "HDD not recognized with new HD cable?"that hard drive, does it have a partition table yet? As I stated previously you will likely need to upgrade some firmware. Here is a link pertaining to this situation: http://support.apple.com/kb/HT2434 Hopefully this will resolve this once and for all. You might have to install it in the other MacBook temporarily so you can use it's disk utility to format the new drive for GUID partition table, otherwise firmware update won't work. Let us know how this pans out for you.
Antwoord op "Will not hold a charge or turn on without being plugged in?"My girlfriend had a HP laptop with the same issues. What I determined happend was she had a bad habbit of walking around with it, while it was plugged in and not supporting the plug. The power supply plug, eventually broke a wire, so it would power the computer, but becuase the battery never received a charge it died. Replaced teh battery, same issue until i discoverd the issue was the power supply. I rebuilt it. Now in your case you've replaced both, leading me to beleive same scenario has occured, only the problem is with the jack in the side of your computer. probably got jared hard enough at one point that may have broke a solder joint. One other thing you might consider is replacing the cmos battery (looks like a watch battery)
Antwoord op "screen backlight not working on MacBook Pro"I'm inclined to beleive a transistor has failed, probably all 4. when you tear it down, look for the side of the logic board usually near the edge, should see 4 transistors in a group, take not of any capacitors you see that have a bulging top, as they are blown and need to be replaced. These transistors are high speed switches that when current levels are right switch the balasts on which are where the backlights get the power. It's possible the balasts are bad, it's possible a simple ribbon cable has come loose. bottom line, look for bulged capacitors first, like a transitor failed and caused a surge which blew the caps. If thats what it is, the fix will cost you about $6 in parts, assuming your willing to desolder and test then transistors (google how to) and solder in new ones. I've fixed half a dozen monitors always the same thing
Antwoord op "Why is it overheating?"cooling fans have likely failed. take it apart, plug it in see if the fans attempt to spin, very likely it's caked with dust. vacuum it out, make sure the fans spin should be ok.
Antwoord op "Why does my 1988 Toyota keep overheating?"Are we sure it's overheating? You could possibly have a bad temperature sending unit. use an ohm meter, the sending unit should read from 0-5 volts, 0 at cold, 5v is overheat. so if that motor is barely warm but it's showing 5 volts the sensors bad. If it's actually running like it's overheating, and your sure it is, try retarding the timing if it seems like it's worse, then advance the timing. Easy to do, losen the holddown clamp on the distributor, enough so you can turn the distributor counter clockwise and clockwise while it's running. if the timing is too advanced it causes a lean condition, which will overheat it. as you turn the distributor back and forth, one way will cause engine speed to increase, the other will slow it down. Find a spot where the idle is reasonable around 5-700rpm tight the distributor and try it. I would say use a timing light, but since I also experienced this problem on mine, when it was timed according to spec it would run hardly, probably because the distributor was a tooth...
Antwoord op "Changed 5 speed tran but will not do anything why?"I'm assuming he means the neutral safety switch. So it won't turn over? or won't start? I'm guessing you are pushing the clutch down when trying it? First be sure your battery has a full charge, if it does, and you turn the key and motor doesn't attempt to start, check the fuse box. test every single fuse, I had a '92 toyota truck that did the same thing to me. Since you swaped the tranny out, did you remember to connect the chassy ground to the engine block? try to give us as many details as you can, like if the motor turns over or not, verify the battery is full charged, don't just turn on the headlights and assume it's ok.
Antwoord op "HDD not recognized with new HD cable?"reseat your hard drive make sure connections are fully seated., if you hear the drive spinning that's good. Does this mac have a BIOS setup? it's possible that your bios firmware doesn't support features on this drive. usually you can upgrade the firmware (get it from apple) but before you do that, take that hard drive out, and try it in another computer, doesn't matter if it's pc or mac. See if the other computer detects it, if it doesn't the drive is dead. If it does work in another computer, the issue is definitely with the mac-book, that's when I'd check on bios firmware updates. Nothing looks broke from the pictures, if you can show bios setup pictures it would help but I suspect you have a bad hard drive. Just because it's a new drive, doesn't mean the guy at best buy didn't accidentally drop it before you got it. :)
Antwoord op "How to remove bios password"Wow everybody wants to get so complicated re-flashing EPROMs and what not before they have all the facts. Has anybody considered the hard drive, SATA has been password locked? If that's the case, toss the drive and install a new one. Don't waste your time trying to hack your way in, unless there is a very specific reason you want access to that data if that's the case hire a forensics team to recover the drive. Its really not that complicated. If it's bios lockout, pull the batterys for half an hour. if it's not a windows lockout, then it's a sata pw lockout.
Antwoord op "Can't get in to computer"Well since nobody can confirm which password was lost, I'll have to assume it was windows. reboot the computer, after the toshiba screen goes away begin tapping F8 key. You will get a list of options, choose safe mode with networking. It should bring up the user screen, showing your account, and Administrator. Login as administrator first try with no password, but it's probably gonna prompt you for a password, try all your normal passwords. One of them is the one you put in when the computer was first setup, it prompted you to set an admin password. And you haven't used that account since which is why it's unfamiliar. Since this is a brand new computer, I assume you probably don't have much personal data on it, ie pictures etc.. worst case scenario have toshiba walk you through reinstalling windows. It's not hard and you can't mess it up, infact it should be automated but it can be fixed.
Antwoord op "PS3 saying hard drive is corrupt"I don't believe you can format that drive in a PC, they usually lock them, in fact the drive is setup as master 0 drive, you will likely mess up the master boot record on your pc, then you will have a inoperable pc and no ps3. If the drive is corrupt, it's likely it's soon to fail. I would uninstall it, don't toss it though, I'm sure ps3 has a special cable you can use to transfer data from the old drive to the new one. I'm not sure on the ps3, but I know the xbox 360 will run without a hard drive you just can't save your games. That would atleast allow you to play until you can find a replacement drive on ebay or amazon.
Pagina 1 van 2