Deze gebruiker heeft hun profiel nog niet ingevuld.
Mijn Handleidingen
Mijn favoriete handleidingen
Vragen
On my Taurus I hooked up a timing light to tell if the plugs were sparking and plugs on cylinders 4,5,6 are working great...
Meer informatieAfter fixing my friends iphone 5s(LCD) it will show no signs of life. it looks like a may have knocked a small component...
Meer informatieWhat would happen if I ran the Mac witgout the top thermal sensor? I got the Mac without one and have it on order but...
Meer informatiemy water damaged iphone 4 say it has signal but i can activate it it just says calling....... call failed any tips?
Meer informatieupon pulling apart an iphone 5s the screen will not show anything. The back light works but the screen does not. I have...
Meer informatieI'm doing a repair on a galaxy tab 2 7 inch this week. I noticed there was no guide on ifixit. Should i document my...
Meer informatieAntwoorden
I would not be too worried. Face ID is not on the screen when disassembled, so I think there will be less of a chance of damaging it. From what I understand the dot projector is unique to each device.
Meer informatieyou would need that adapter to keep it quiet. and if you clean the old adhesive very well and get it nice and flush you can make it look factory.
Meer informatiewhen you turn it on press atl and f10 and it should open eRecovery Management. select Restore Operating System to Factory Defaults. It should restore again this time just make sure it's plugged in :)
Meer informatieI've heard of heating the Baseband chip for 4-5min at 400f and it fixing it. but first try backing up and restoring. if it throws error -1 then try reflowing the chip.
Meer informatieCheck to make sure the LCD cable has a solid connection, and make sure the connector is not bent. Try another screen and if possible try it on another 4s.
Meer informatieCheck the cables at the bottom of the device where the lcd connects
Meer informatieYour best will be to reinstall the OS from a disk.
Meer informatieIf this happens often it maybe time for a new launcher. I find the Google Now launcher really nice. You can download it from the google play store and when installed, press the home button and it will have a pop up message, select Google Now launcher and click for it to always do this. Finally, just rearrange your icons and your good. This works on almost all launchers and some are better than others, I like google now but there are others like GO! launcher and more.
Meer informatieIf the frame is not the exact one, for example the i535 frame will only work with the i535 motherboard. The motherboards are slightly different but can still fir i would check this first(see below) https://www.gazelle.com/thehorn/wp-content/uploads/2013/05/IMAG0098-e1370597945201-1024x646.jpg for example this one is the T999. You find this by taking the model number and remove the first 3 letter and the dash.
Meer informatieSprint and verizon are CDMA unless its 4G LTE. You would need to flash the phone to use with another network.
Meer informatiePagina 1 van 8
Commentaar Gids
Which Module is used for the gamepad?
The reason I recommend removing it is to help prevent the battery and motherboard from being accidentally heated. I know that if you do it just right there will be no heat applied to them but I'd rather be safe than sorry!
its now finished
Look at what you have to do to replace the screen on both devices. the edge needs to have complete disassembly the watch just pops off. the battery on the edge requires removing the back glass and a complete teardown, the watch just remove the screen and there sits the battery
Stemmen
7
3