Hello. When I was removing the screen from my Sony Ericsson W580i, I accidentally broke a tab on the top of the screen...

Hello everyone. I have a Sony Ericsson W580Ii with a screen issue. It dropped on the ground (not on display side, but...

Hello everyone. I have an issue with my Sony Ericsson Z520i. I cannot see anything on the display, but the phone is...

Hello everyone. My Sony Ericsson W150i Yendo is blocked on T-Mobile SK. Can I get an unblocking code to unblock that...

Hello everyone. I have an issue with my Sony Ericsson W995. It is not responding to power button and to charger. I...

If your buttons don't work, this may be because the front keypad UI is faulty or there's bad flexible cable connecting the front keypad UI to the mainboard.

I don't know where and you did apply that high voltage. I except that the charging port and power management IC have been gone in smoke. If you haven't opened your Walkman after the voltage damaged it, possible more components (like internal flexible cable, display, LCD flexible cable, front keypad UI and keyboard UI) have been destroyed. Phones don't have a fuse if it is dead.

E100 error means internal hardware failure of your Xbox. This may be the cause of a bad HDD, boot sector virus or faulty SATA controller on motherboard. Your Xbox needs service.

This problem looks like a dead battery. Try replacing the battery. If it does not help, remove the battery and clean the contacts. Because your question mentions that, when you try to turn it on, the screen gets a little brighter, then turns off again, it means this: #1: Crashed firmware or EROM - full flash needed - bring your Walkman to service* #2: Damaged LCD flexible cable - display replacement needed - bring your Walkman to service (1) The service dealer can ask you for more fees, because this is old phone and all data will be deleted. I don't know about the price of flashing firmware in USA, but in Slovakia the service dealers don't have a tools or hardware for these old phones.

If you forgot your phone lock code, you must bring your Walkman to the authorized service dealer. The dealer may ask you for more fees and your data will be deleted.

The blinking red light is the common EROM error. Your phone needs a full flash, which needs a service. You must also say bye bye for your photos, because the data in the phone will be lost during flashing.

If you get a blank screen, try lighting a torch to the display to check that the images are visible. If are visible, there might be a display illuminance problem. If there is a illuminated blank screen, there is a bad flex ribbon cable connecting the display to the motherboard.