it is not soldered it has legs to snap into place no one sells just the sd card holder,just the motherboard,i looked but did i overlook one here is take apart video https://www.youtube.com/watch?v=Xq3c90Am... the sucker is glued in places and epoxy applied at lens once removed front cover is distorted due to heat making some part malleable because the lens area with epoxy is removed by pulling leaving a rugged rock hard all terrain surface it cannot be removed the rest is screws with torque screwdriver follow take apart video and pay attention to removing the battery holder now you will see motherboard and sd card holder to remove mother board and you’ll see use philips 0 screwdriver to remove mother board check underside of motherboard for sd card colder mounts 1.you will need to purchase a new front cover that will fit, but not flush due to epoxy residue, camera is no longer waterproof when taking apart some screws just spin.had to cut off with dremel and once the board has been removed,pulled the screw...