Erik Gregg

Tying threads together for this issue, I have a potential solution here: Whirlpool Dishwasher stops after filling with water

Tying threads together for this issue, I have a potential solution here: Whirlpool Dishwasher stops after filling with water

Tying threads together for this issue, I have a potential solution here: Whirlpool Dishwasher stops after filling with water

Tying threads together for this issue, I have a potential solution here: Whirlpool Dishwasher stops after filling with water

For anyone tracking this megathread, I have a new unique solution to this issue that I haven’t seen ANYWHERE else. For the record, here were my symptoms: (1) Would fill with water just fine (2) Clicking noises would occur but circulation pump would never turn on (3) Would drain just fine and fill again, with no circulation pump running at all at any point (4) Upon opening, no spinning or spraying at all, lots of steam. (5) Randomly would work and not work, didn’t have any particular pattern (6) Seemed to work better after power was cut for a while as others have said. Never played the circuit breaker game, but did observe this from working on it repeatedly with the power off. Here were the solutions I tried: (1) Replaced the heating element after getting 7-1 the first time. New element has consistently ohmed right. (2) Replaced the control board. This changed my codes from 7-1, 7-2 consistently to just 6-4 or nothing at all when doing a full diagnostic run. (3) Replaced the circulation pump. Measured ohms...