Deze gebruiker heeft hun profiel nog niet ingevuld.
Antwoorden
@ryan_nyc below is how it should look if the glass was removed correctly. Note that there should be glue residue but this one has been cleaned and is actually off the frame also.
Meer informatieYes. It should look like this. Pic on left with the housing like yours. Your LCD is now broken and considered BER.
Meer informatieWithout pics I can’t be certain. But here are a few things I can let you know. Glass is suppose to be clear. If you removed the Glass only it should also be clear with black borders. Your LCD that is still on the frame should be black (see image), if it does not look like that, you probably removed the Polarizer film along with the glass and it is still on the glass. In that case your LCD is damaged. Try testing to see. I also added an image of the LCD’s back side if it were removed from the frame.
Meer informatieyes, all G935 (S7 edge) screens can you be used for any s7 edge carrier/region phone you have. G9350 would be southeast Asia model most likely Hong Kong, G935V is verizon, but like i said all Screens are compatible for any region.
Meer informatiemy suggestion is first see if it is the battery problem. instead of purchasing a new one, you should go to your local repair store and check with a different battery if it charges. Most repair stores will have Note 4 batteries just lying around. if problem persists then yes, it most likely is the charging port.
Meer informatiethere are couple of reasons for this. one might be your antenna cables are not on properly. the signal antenna is connects from your SUB PBA (daughter board) to your main PBA board. another problem which I think might apply to you if you changed the frame to a new one is that the frame has RF(radio frequency) issues. you would have to replace the frame. when getting a new frame, it is best to get a refurbished OEM frame than getting a copy one as you won’t be able to find OEM brand new frame in the market.
Meer informatieI’m guessing it is one of these reasons. 1) you damaged the FPCB (Flexible printed circuit board) which is the cable on the LCD when you swapped MB’s. With an image i would be able to verify. Fix: Replacing the FPCB on the LCD. Need Flex cable laminating machine which you won’t have so replacing Screen is only option. 2) you damaged the connector either on your MB or the FPCB. Fix: you can try replacing the connector. Need to know how to solder
Meer informatieyou can apply the OCA to the glass substrate with a roller but the roller has to be made for S7 Edge or you will have bubbles on the edge of the glass (Curved Area). For the lamination of LCD to glass you will not be able to do without a vacuum lamination machine and an autoclave to remove the small bubbles that will appear. From experience, I have yet to see it done.
Meer informatieIf you are referring to the LCD digitizer, then no. They are not compatible as S6 active has more pins in the connector.
Meer informatieiyoungstai
@iyoungstai
127
Reputatie
9
Oplossingen
0
Handleidingen
Lid sinds 03/28/19