Deze gebruiker heeft hun profiel nog niet ingevuld.
Vragen
Hi, I done a housing replacement for an iPhone 7 but removing the sim try is very fiddly, the sim ejector does not sit...
Meer informatieI have done many repairs before so I am not a total noob however I have just recently attempted to do a glass only screen...
Meer informatieI have a relatively new battery on my iPhone 7 and it’s still at 100% of maximum capacity and it had very good battery...
Meer informatieThe screen went black randomly although backlight was still working, I thought this was a screen problem so I replaced the...
Meer informatieI know the finger print scanner will never work but I am unsure if the button will not work. If I get a replacement home...
Meer informatieI bought an iPhone 7 with a broken screen and after I replaced the screen the home button and the earpiece and front...
Meer informatieAfter screen replacement my screen won’t turn on. The phone was switched of and the repair was done. When the new screen...
Meer informatieThere is an invisible bar down the left side of me phone which I can’t tap on so the ‘p’ on my keyboard doesn’t work and...
Meer informatieI have an iPhone 6s battery and I have an iPhone 6 could I use the 6s battery for my 6
Meer informatieThe screen is popping out at where the volume and mute buttons are after a screen replacement.
Meer informatiePagina 1 van 2
Antwoorden
Look at the original screen and bend the cable in the exact same way. The original should have same sized cable but it’s usually bended in a way for it to fit in flush.
Meer informatieMy guess here is you have damaged the microphones in your phone which is easily done as they are so delicate. Try replacing them and your problem will be fixed.
Meer informatieUse the official Apple cable if you still have it, or borrow one from a friend as the cable is usually responsible for error 9 to occur If that doesn't work, it might also have something to do with the IPSW you are trying to restore with. Try using a different IPSW or using Redsn0w to boot Pwned DFU mode and restore it like that. Error 9 can be related to the RAM disk kernel rejecting the ASR because it is not signed properly, thus breaking the connection with the device and causing error 9.
Meer informatieDid you disconnect the batter before repair and connect the battery last after the repair? This can happen if you have damaged the home button flex. Maybe the first screen was faulty but when transferring components to the new screen then you may have damaged it the home button flex. Another reason could be you somehow damaged the battery when repairing the screen however that isn’t very likely to happen.
Meer informatieThe cover is for protection and slightly makes it sounds better if you take off the cover you won’t notice much change but will have to be careful to not damage it
Meer informatieMaybe a problem with the motherboard. If you have warranty try sending it pack to Sony.
Meer informatieYes it will fix it if it’s not a faulty screen but a logic board will cost you as much as a new phone better off getting it repaired from a place that offers micro soldering or just buying a new phone.
Meer informatieFirstly when you buy a screen it will come with both the screen and digitizer. Which is fine and you can easily assemble this into the phone, if you replace with a LCD instead of OLED then you will notice a change as the LCD is not as sharp as OLED and the LCD also uses a backlight which OLED does not
Meer informatieDid you fix the phone then update? This can cause the phone to brick. If the phone is working then you either damaged the screen during the repair or the screen was already faulty
Meer informatieThe new logic board can be iCloud unlocked and network unlocked although you would need to check which board you are buying. I would recommend selling your phone for parts and buying a new phone as a logic board would cost as much as buying a new phone.
Meer informatiePagina 1 van 5