Help
We offer cell phone, tablet and computer repairs in our...
Gebeurtenis | Telling | Delta |
---|---|---|
Iemand heeft jouw handleiding afgewerkt | 43 | 120 |
Post is positief beoordeeld | 1 | 12 |
Gecontroleerde wijziging aan een handleidingsstap geaccepteerd | 3 | 3 |
Gecontroleerde wijziging aan de handleiding geaccepteerd | 2 | 2 |
Gecontroleerde wijziging aan een handleidingsstap geaccepteerd | 1 | 1 |
You don't need to remove the screw on the wifi module and remove the card; just unclip the two antennas from the card.
On my model there were only two Phillips screws as the third (inner most screw) was removed during bottom cover removal (Under the rubber foot).
On my model there were only two Phillips screws as the third (inner most screw) was removed during bottom cover removal (Under the rubber foot).
Disconnect the battery FIRST! Using a flat PLASTIC spudger, slide it sideways under the clip and wiggle upwards until connector comes loose.
T4 screws on all but the two under the rear rubber feet; those are Phillips PH0 (and my model had two square rubber feet).
This alternative method only reboots the watch.
You may need to wiggle the board slightly to remove the upper portion of the other board from under the front facing camera on the right.
Not sure what you’re asking; if your asking if the iPhone 8 battery will fit in an Xr, or vise-versa, the answer is no.
Well, nice description, but you need to remove the bottom cover by first removing all the screws, then using a pry device, sliding it around the edge until you can pop off the bottom cover. THEN you can access the four screws on the battery.
There is also another connector directly to the right (in this photo) that needs to be disconnected as well (this picture shows it under the logic board, so this has already been removed and replaced before the photo was taken).
Pagina 1 van 3
Volgende