Handleidingen waar ik aan meegewerkt heb
Booting and freezing issuesHello everyone. I have a Dell Inspirion 7000 series - 7737 Laptop in my repair shop. The clients could not get the laptop...
Touch screen not fully workingHello everyone, I recently have just repaired a customers iPhone 6. Repair went well but after 1 day the customers touch...
Antwoord op "The screen doesn't feel the touch "the touch doesn't work""Try Completing a factory reset. First make sure the phone is turned off. 1. Hold the Volume up Button 2. While holding the volume up button press and hold the power button 3. Once the phone turns on release the POWER button only while still holding the volume up button 4. A list of languages should appear select using thevolume keys to move up and down and the power button to select. 5. Next screen scroll down to "Wipe data and factory Reset" 6. Scroll down to "YES" 7. Clear system cache 8. Select Rebot System now If that does not fix it have you dropped the device? Or damaged it ?
Antwoord op "Fuzzy screen after replacement?"Minho is correct with the possability of you having faulty screens (Watch where you order from). When installing the aftermarket screen make sure the connector is properly seated. Also make sure that you have disconnected the battery. After Installation is complete reconnect the battery and the screen should be clear. If not send back your faulty screen. I do not beleive its your logic board as you would be having other issues but logic boards can be damaged fairly easily if you are not careful.
Antwoord op "iPad 2 Wi-Fi EMC 2415 battery not charging"Hi James, Did you do the repair yourself or through a repair shop? Either way its very possible that the ribbon cable could have been damaged or even melted when the screen was removed. First I would plug your charging into your ipad give it roughly 5 second and check to see if you have any sort of background light turn on. If you do its not your charging port. Also its possible that the ribbon cable connection was not seated properly on the logic board. If your charging cable still shows signs that it is charging your batter could be bad and may need to be replaced. I hope that helps! Best of luck, Chris D