I saw on a Youtube video you can use the center hole of the charging base instead of pliers. It fits perfectly on mine.

I am working on a 7” lite E. Is the procedure about the same?

I only had to replace the digitizer on mine, lcd was good.

Heat did the trick for me. Start at the end with the bottom so it can hinge to finish. I also put packing tape on the edges so the glass might stay in place.

Thanks for the guide!

You could probable get by with two small zip ties to hold it in place for each that break.

https://www.patagonia.com/returns.html

Check out the How I built this episode with the Patagonia founder.

https://itunes.apple.com/us/podcast/pata...

https://www.stitcher.com/podcast/nationa...

I hope you show the second part were you replace the 72pin connector. Please include part source.

The 72 pin connector grabs too tightly on the cart.

Thanks.

Why would you include a link to installing High Sierra with the guide for installing Mac OS X on a G4 Powerbook?

I just finished installing a new battery in my iPhone 5 with the iFixit iphone 5 kit and battery.

-The kit looks very nice but I couldn’t remove any internal screws with the P000 driver. I used a Craftsman P00 to remove the internal screws. They wouldn’t turn with the Craftsman P00 screwdriver I have either.

-The screws holding down the monitor connectors would not turn either. The craftsman drivers wouldn’t turn them either. So I removed and replaced the battery while the screen was connected.

Even with the problems, this was the easiest apple battery to replace.

Thanks!

I am surprise he wasn’t wearing gloves.

I didn’t know this was possible.

Thanks!

I completed this tonight.

One place I would express a little more care is when working around the front button. I tore the back of the button slightly when I was removing the digitizer.

Question: what is best for removing the adhesive around the frame? I was using what was on hand (valve oil for a trumpet). It worked but the adhesive should of come off without so much effort. A lot more scarping. I have used Goo Gone before but it seems very messy.

This was the third android tablet I have replaced a screen and or digitizer before (all Galaxy Tabs).

Thank you for the guide.