hi 1st check your fuel system if it feeds correctly and make sure the carburators are clean 2nd check your high tension wires if it does fire up your spark plugs hope it helps
hi there, there is few possible things could happen when you power wash your bike : *the water liked in to its air cleaner and mixing with the fuel system . (1) high tension wires got wet [interrupts the electrical flow to your spark plugs]. * electrical system eq. computer box, egnition coil etc... (1) water got through your tank. *if sprayed on the pipe water it settling inside your exhaust system with a little bit of water mixture on this places,engine sputters, back fires or sometimes it wont even start at all. well to fix it try this procedures and test run it if you finish one. 1. make sure air filter is dry if not air dry it including its housing. 2.make sure your bike is completely turned off when you check your high tension wires going to the spark plug or you might get cranky (shocked).if wet air dry it including the plugs towards the spark plugs. 3. if you see a wet spot on some of your electrical system air dry it. 4. check your fuel filter try draining fuel out of it and check if water did mix...