Deze gebruiker heeft hun profiel nog niet ingevuld.
Vragen
My iPod 3rd gen doesn't start, it shows the Apple logo then it disappears and the HDD keeps spinning. I got it into...
Meer informatieI have a couple of Xbox 360s, one of them got the RRoD and I decided to swap the hard drive to the other Xbox, that Xbox...
Meer informatieI was trying to watch a movie in my '06 MBP and suddenly I got a message "Disk can not be read" (movie was on a flash...
Meer informatieI was performing an update on my mid-2007 15” MBP, from OSX 10.7.5 to 10.11 “El Capitan”. While I was doing the update the...
Meer informatieMy iPod turns on with a charged battery only to show the empty battery icon and turn off. The iPod wasn’t charging through...
Meer informatieMy 3rd gen iPod was working fine until a couple months ago when I let the battery drain. When I tried to recharge it about...
Meer informatieI recently replaced the screen and digitizer of my iPhone 4S. After reassembling the iPhone turned on and connected to the...
Meer informatieI recently purchased an old Gevey Ultra S SIM card (the one that didn't came with the White Reset SIM) to use it on a GSM...
Meer informatieI have purchased a 1TB 2.5" Hybrid Seagate HDD (ST1000LM014) for my Early-2011 MBP, so I have several questions regarding...
Meer informatieThe clickwheel connector on my 60gig iPod Photo (Late 2004) became detached from the logic board, and since It's the...
Meer informatiePagina 1 van 2
Antwoorden
Hello folks. I'm still trying to fix my iPod, but it has been troublesome since I have no idea where to start or what to replace. I think that this issue might be caused by a faulty power management IC or FireWire chip, however, these models tend to short pretty frequently, based on this, I decided to upload pictures of the logic board of my iPod 3rd gen to check which are the parts in the logic board that handle the FireWire 12V output. If any of you'd like to help I uploaded the pictures into this google folder: https://drive.google.com/drive/u/1/folde... What's the point of this? I would like to start to create a post that can outline the chips in the 3rd gen logic board, I believe that a handful of us iPod collectors still use and care for this model, being so prone to shorts I think that a guide with the chips that handle and distribute the 12 Volts would be pretty useful.
Meer informatieHello, do you notice any heating on the right side of your iPod (near the FFW button)? Maybe the iPod shorted out.
Meer informatieThis might point to a hard drive failure. Try putting the iPod into disk mode (first, reset the iPod pressing Menu + Center buttons for about 5sec until the screen goes black, immediately press Center button + Play) and try to restore the iPod this way. If it still doesn't show up or restore, your hard drive might be failing.
Meer informatieFor what I've seen in some of these 5ths gens the center button tends to move after a considerable amount of use. What you can do is take apart the front assembly and check the center button. It should have a small black rubber button below, taped into the logic board with yellow tape, usually this button moves from its position and you have to put it back on. For these kind of repair I use a tiny bit of adhesive and place the button in place. With just enough adhesive the button won't move from its position and it'll click fine. If that doesn't work, try removing the small black rubber button and check for corrosion, you could also try cleaning with a little bit of alcohol. If you need a guide on these repair you can ask me how and I'll post pictures of the procedure in here.
Meer informatieHello, do you plug it in to the wall charger or computer?
Meer informatieJust found the solution, I replaced the RAM module with a 1GB one, then booted the computer and it turned on! After that, I cleaned the original RAM module (2gigs) with rubber, put it back and it is working!
Meer informatieI looked this diode on a broken logic board that I have and it is named DZ3, if I recall correctly, one of these handle the firewire or USB output to the logic board (the other one is DZ1 an inch away). You might replace it with another one from a spare logic board.
Meer informatieIt looks like you got a battery for the 160gb thick model from 2007 (6th gen), and yours might be 2009 model (7th gen) is slimmer. You need to check which model you have by pasting your iPod's serial number on this site: http://www.chipmunk.nl/klantenservice/ap.... It'll show you info about your iPod's production date and generation, from which you can tell which model is it.
Meer informatieThis might point out to a display related issue. Did you try replacing with one from another iPod? Spare displays some times can cause trouble because their quality is not as good as the original parte.
Meer informatieI don’t know the actual pinout for the audio flex connector but I have a spare one (I could give it to you for free but I’m in Venezuela). If you want I can send you a PM or an email with images of the connector for you to check the pinout.
Meer informatiePagina 1 van 2
Topo Ceni
@topoceni
111
Reputatie
20
Oplossingen
0
Handleidingen
Lid sinds 12/23/14
Stemmen
18
0