Gereedschappen die in deze demontage worden gebruikt

Inleiding

This guide provides step-by-step instructions on disassembling the Picstart Plus development programmer.

Deze demontage is geen reparatiehandleiding. Om je Picstart Plus Development Programmer te repareren, gebruik onze reparatiehandleidingen.

  1. Remove 4 Phillips screws located on the back side of the holding plate.
    • Remove 4 Phillips screws located on the back side of the holding plate.

    • After the screws are removed, remove the case of the development programmer.

    • Carefully take out the circuit board with component side facing up. Put the case aside.

    Voeg opmerking toe

  2. Disconnect the microcontroller module from the main board using a spudger or a similar tool.
    • Disconnect the microcontroller module from the main board using a spudger or a similar tool.

    • Set the microcontroller module aside.

    Voeg opmerking toe

    • Flip over the mainboard so that the component side is facing down and remove the small Pan head screws that holds the cover of the IC holder

    • Remove the cover of the IC holder.

    Voeg opmerking toe

    • Remove the IC holder lever along with the small metal plate that covers the lever.

    • Set the lever and the lever cover aside.

    Voeg opmerking toe

    • Congratulations! You have completely dismantled the PICSTART Plus Development Programmer!

    • All the extracted components are shown in the picture.

    Voeg opmerking toe

Brad

Lid sinds: 17-11-13

624 Reputatie

2 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 16

Altijd: 1,444