Repareer je spullen Gemeenschap Winkel

iPhone 6 电源键组更换

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 2 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Chinees
Stap 2
iPhone 6 Power Button Cable Assembly Replacement: stap 0, afbeelding 1 van 3 iPhone 6 Power Button Cable Assembly Replacement: stap 0, afbeelding 2 van 3 iPhone 6 Power Button Cable Assembly Replacement: stap 0, afbeelding 3 van 3

  • Gently pull the battery adhesive tab away from the battery, toward the bottom of the iPhone.

  • Try not to pull against the battery or the lower components, or you may rip the adhesive strip.

  • Continue pulling, allowing the strip to slowly slip out from between the battery and the rear case. When you feel increased resistance from the strip, stop pulling and continue with the next step.

  • If the battery adhesive tabs break off at any point during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.

  • If one of the adhesive strips breaks under the battery during this procedure, and cannot be retrieved, remove the remaining strip, and then proceed to Step 44.

轻轻地胶带从电池底部拉出来，并轻缓地向手机底部方向用力拉出。

在撕的过程中，尽量避免碰触到电池或是下方的零件，因为这样有可能造成胶带断裂。

请继续撕，直到胶带从电池与后盖间分离。当你感觉到胶带长度已经被拉到极限时，请停止拉扯，并接着下个步骤。

若胶带在撕的过程中发生断裂，请用手指或是镊子夹住剩下的胶带，继续撕。

若其中一个胶带在撕的过程中断裂，并无法用以上方法继续撕的话，请直接跳到步骤44。

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.