Repareer je spullen Gemeenschap Winkel

MacBook Pro（13英寸，带有Retina显示屏，2013末）电池更换

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 6 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Chinees
Vorige stap

Stap 16 vertalen

Stap 16
MacBook Pro 13" Retina Display Late 2013 Battery Replacement: stap 0, afbeelding 1 van 2 MacBook Pro 13" Retina Display Late 2013 Battery Replacement: stap 0, afbeelding 2 van 2

  • Remove the battery.

  • Before installing your new battery, remove all the old adhesive from the MacBook Pro's case.

  • With a little luck, you can slowly pull out each strip of adhesive with your fingers.

  • Otherwise, soak each section of adhesive with a bit of adhesive remover for 2-3 minutes, and then scrape it out with an opening pick or one of the other tools in your kit. This can take quite a bit of work, so be patient.

  • Mop up any remaining adhesive remover and give your MacBook Pro a few minutes to air dry.

  • The replacement battery included in your iFixit kit comes with adhesive pre-installed. Test the battery's fit and alignment carefully before peeling off the film covering the adhesive, and then press each cell firmly into place. If any additional films/liners are present that weren't on your original battery, remove them now.

  • Calibrate your newly installed battery: charge it to 100%, and keep charging it for at least 2 more hours. Unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook Pro's SMC.

移除电池

安装新电池之前，请从MacBook Pro中取出所有旧胶。

有点运气的话，你可以用手指慢慢拉出每一块粘合剂。

否则，用一点粘合剂去除剂将每个粘合剂部分浸泡2-3分钟，然后用开口或其他工具将其刮掉。 这可能需要相当多的步骤，所以要耐心。

将任何剩余的粘合剂去除剂拖下来，并将您的MacBook Pro放置几分钟即可风干。

iFixit套件中包含的更换电池预先安装了粘合剂。 在剥离覆盖胶粘剂的胶片之前，仔细测试电池的配合和对准，然后将每个电池牢固地按入到位。如果更换电池上有原电池上不存在的胶片、衬垫，请将它们移除。

校正 你新安装的电池: 将电池充电至100%并继续充电至少两小时，然后拔掉电源正常使用你的电脑。当出现低电量警告时，保存你的工作并继续使用电脑直至电量低自动休眠。静置至少5小时后一次性充电至100%。

若更换新电池后出现任何不寻常的问题，您可能需要重置你 MacBook Pro 的 SMC.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.