Logitech G502 Hero Side Buttons Board Replacement

Terug naar de handleiding

Engels

Nederlands

Stap 4 vertalen

Stap 4

Logitech G502 Hero Side Buttons Board Replacement: stap 0, afbeelding 1 van 3

Logitech G502 Hero Side Buttons Board Replacement: stap 0, afbeelding 2 van 3

Logitech G502 Hero Side Buttons Board Replacement: stap 0, afbeelding 3 van 3

If your replacement board doesn't come with a cable, follow this step to remove and transfer the old one.
Set the board down on a clean, ESD‑safe surface so the side with the cable is facing up.
Use the point of a spudger to lift the locking flap on the ZIF connector.
Pull the cable straight out of its socket.
When installing the cable into the ZIF connector, make sure the ridged side is facing up.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.