Beschrijf het specifieke gedeelte of onderdeel van deze device waar u mee bezig bent. Voorbeeld: batterij
Maak een titel aan.
Geef achtergrondinformatie weer voordat de lezer de handleiding induikt.
Stap 1 — Uncover and Remove the Screws
Remove the ball and flip the base over.
Stap 2 — Opening the Case
Using an opening pick, pry up the lower case from the bottom.
Stap 3 — Remove the Circuit Board
Flip up the retaining lever of the ZIF connector on the horizontal optical sensor.
Stap 4 — Dust the Circuit Board
Dust the button contacts by pressing on them with a spudger and blowing into them with a hand blower. Repeat ten to twenty times for each of the four contacts.
Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.