Repareer je spullen Gemeenschap Winkel

여는 절차

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 19 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Koreaans
Stap 10
Opening Procedure: stap 0, afbeelding 1 van 3 Opening Procedure: stap 0, afbeelding 2 van 3 Opening Procedure: stap 0, afbeelding 3 van 3

  • Insert a new opening pick into the bottom left corner and slide it around the corner toward the left edge.

  • Be careful cutting under the lower 2.5 inches (65 mm) of the left edge. Don't insert the opening pick more than 1/8 inch (3 mm) here. The display cables sit near this part of the bezel and are easily damaged.

  • Once past the display cable area, you can insert the pick to 0.45 in (12 mm) again.

  • Slide the pick along the left edge of the Surface to cut through the screen adhesive.

  • Leave this pick in the left edge to prevent the adhesive from resealing.

새 여는 픽을 하단 왼편 모서리에 끼우고 왼편 가장자리를 향해서 모서리를 따라 미세요

왼편 가장자리 하단 2.5인치 (65mm) 밑을 자를 때 조심하세요. 여는 픽은 1/8인치 (3mm) 이상 끼우지 마세요. 디스플레이 케이블은 베젤의 이 부분 근처에 있으며 쉽게 손상됩니다.

일단 디스플레이 케이블 영역을 지나면 픽을 다시 0.45in (12mm) 끼울 수 있습니다.

Surface 왼편 가장자리를 따라 픽을 밀어서 스크린 접착제를 자르세요.

접착제가 다시 붙는 것을 방지하기 위해서 이 픽을 왼편 가장자리에 그대로 두세요.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.