Repareer je spullen Gemeenschap Winkel

Hauptplatine entlöten

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 3 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Duits
Volgende stap

Stap 1 vertalen

Stap 1
Motherboard Desoldering, Desolder the vibration motors: stap 0, afbeelding 1 van 3 Motherboard Desoldering, Desolder the vibration motors: stap 0, afbeelding 2 van 3 Motherboard Desoldering, Desolder the vibration motors: stap 0, afbeelding 3 van 3
Desolder the vibration motors

  • The next few steps require desoldering and soldering connections. To learn how to solder, check out our soldering guide—if you've already soldered, you can still find some helpful tips and tricks in this guide!

  • Flip over the controller and motherboard.

  • Use a soldering iron to desolder the vibration motor wires from the motherboard:

  • Two red wires

  • Two black wires

  • During reassembly, remember to solder the wires back into the same position. The red wires belong closest to the edge and next to the Rs on the motherboard.

Vibrationsmotoren entlöten

Drehe den Controller und die Hauptplatine um.

Entlöte die Kabel der Vibrationsmotoren mit Hilfe eines Lötkolbens von der Hauptplatine:

Zwei rote Kabel

Zwei schwarze Kabel

Denke beim Zusammenbau daran, die Kabel wieder an der gleichen Position zu verlöten. Die roten Kabel gehören direkt an den Rand neben den Rs auf der Hauptplatine.

[title] Desolder the vibration motors
+[* icon_note] The next few steps require desoldering and soldering connections. To learn how to solder, check out our [guide|750|soldering guide|new_window=true]—if you've already soldered, you can still find some helpful tips and tricks in this guide!
[* black] Flip over the controller and motherboard.
[* black] Use a soldering iron to desolder the vibration motor wires from the motherboard:
[* red] Two red wires
[* black] Two black wires
[* icon_reminder] During reassembly, remember to solder the wires back into the same position. The red wires belong closest to the edge and next to the ***R***s on the motherboard.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.