Ga door naar hoofdinhoud

Remplacement du trackpad (pavé tactile) du MacBook Pro 13" Touch Bar 2018

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 3 handleidingen die deze stap bevatten.

Stap 4
MacBook Pro 13" Touch Bar 2018 Trackpad Replacement, Heat the trackpad cable: stap 0, afbeelding 1 van 1
Heat the trackpad cable
  • Prepare an iOpener and lay it on top of the trackpad ribbon cable for about a minute, in order to soften the adhesive securing the trackpad ribbon cable to the top of the battery.

  • If you don't have an iOpener, use a hair dryer to warm up the cable instead. The cable should be warm, but not too hot to touch. Be careful not to overheat the battery.

Préparez un iOpener et posez-le sur la nappe du pavé tactile pendant environ une minute, afin de ramollir l'adhésif qui la fixe à la batterie.

Si vous n'avez pas d'iOpener, prenez un sèche-cheveux pour faire chauffer la nappe. Celle-ci doit être chaude, mais pas brûlante au toucher. Faites attention à ne pas surchauffer la batterie.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.