Repareer je spullen Gemeenschap Winkel

华为 Mate 10 后盖更换

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 5 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Chinees
Stap 2
Huawei Mate 10 Back Cover Replacement: stap 0, afbeelding 1 van 3 Huawei Mate 10 Back Cover Replacement: stap 0, afbeelding 2 van 3 Huawei Mate 10 Back Cover Replacement: stap 0, afbeelding 3 van 3

  • Place a suction cup near the bottom edge of the back cover, on the right side (opposite the speaker grille) of the USB-C charging port, above the microphone hole.

  • If your back cover is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere. If all else fails, you can superglue the suction cup to the back cover.

  • Pull on the suction cup with strong, steady force to create a gap.

  • Due to the adhesive's strength, this is very difficult and may take multiple attempts. If you can't create a gap, re-apply heat and try again.

  • Insert the point of an opening pick into the gap.

在USB-C充电端口的右侧（与扬声器网罩相对）的后盖底边缘附近，将吸盘放在麦克风孔上方。

如果后盖严重开裂，请用透明的包装带覆盖它，以使吸盘粘附。如果所有其它方法均无效，则可以将吸盘与后盖粘在一起。

用强大的稳定力拉动吸盘以形成间隙。

由于粘合剂的强度，这是非常困难的，并且可能需要进行多次尝试。如果无法形成间隙，请重新加热并重试。

将三角撬片的尖端插入间隙中。

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.