How To Replace Custom-cut Adhesive For Samsung Phones

Terug naar de handleiding

Engels

Nederlands

Vorige stap Volgende stap

Stap 2 vertalen

Stap 2

How To Replace Custom-cut Adhesive For Samsung Phones, Fingerprint sensor and gasket adhesive: stap 0, afbeelding 1 van 3

How To Replace Custom-cut Adhesive For Samsung Phones, Fingerprint sensor and gasket adhesive: stap 0, afbeelding 2 van 3

How To Replace Custom-cut Adhesive For Samsung Phones, Fingerprint sensor and gasket adhesive: stap 0, afbeelding 3 van 3

Fingerprint sensor and gasket adhesive

The following three steps show how to remove and transfer the fingerprint sensor and its gasket.
If your phone's fingerprint sensor and camera reside on a single rear bezel (like on the S9), you can transfer that bezel without removing the parts individually.
Heat an iOpener and apply it to the fingerprint sensor for one minute.
Use an opening tool to gently pry the fingerprint sensor at the lower seam, where it contacts the back cover.
Do not pry at the upper seam, which is the fingerprint gasket seam.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.