How To Replace Custom-cut Adhesive For Samsung Phones

Terug naar de handleiding

Engels

Nederlands

Vorige stap Volgende stap

Stap 5 vertalen

Stap 5

How To Replace Custom-cut Adhesive For Samsung Phones, Rear bezel: stap 0, afbeelding 1 van 3

How To Replace Custom-cut Adhesive For Samsung Phones, Rear bezel: stap 0, afbeelding 2 van 3

How To Replace Custom-cut Adhesive For Samsung Phones, Rear bezel: stap 0, afbeelding 3 van 3

Rear bezel

The following four steps show how to remove and transfer the rear bezel. The bezel supports the rear cameras, flash, and the fingerprint sensor (on some models).
Heat an iOpener and apply it to the rear bezel for a minute.
Starting from the outward-facing side of the back cover, push the bezel inwards with a finger to loosen the bezel from its cutout.
Do not push too hard, or you may bend the bezel.
Alternatively, you can pry around the bezel with an opening tool to loosen it from the back cover.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.