Inleiding

The battery is quite simple to replace in a Roomba, and only requires removing the side brush and bottom plate before it can be accessed.

Onderdelen

Geen onderdelen nodig.

Place your Roomba upside-down on a hard surface.
  • Place your Roomba upside-down on a hard surface.

If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

David Forrest - Antwoord

While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
  • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

Voeg opmerking toe

  • Gently pull upwards on the brush to remove it.

Voeg opmerking toe

  • Rotate the Roomba upside-down so the bottom is facing towards you.

Voeg opmerking toe

  • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

Voeg opmerking toe

  • Carefully lift the bottom plate.

  • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

Voeg opmerking toe

  • Lift and remove the old battery by pulling the tabs on both sides.

  • Gently replace with a new battery.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

5 andere personen hebben deze handleiding voltooid.

Deborah Newberry

Lid sinds: 23-01-14

551 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 13-14, Regan Winter 2014 Lid van Cal Poly, Team 13-14, Regan Winter 2014

CPSU-REGAN-W14S13G14

4 Leden

13 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 19

Altijd: 2,627