Ga door naar hoofdinhoud

MacBook Pro 13" met Twee Thunderbolt-poorten 2019 Vervanging van de batterij

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 2 handleidingen die deze stap bevatten.

Engels
Nederlands

Stap 1 vertalen

Stap 1
MacBook Pro 13" Two Thunderbolt Ports 2019 Battery Replacement, Remove the battery: stap 0, afbeelding 1 van 1
Remove the battery
  • Use a T5 Torx driver to remove the two 3.1 mm screws securing the battery board.

  • These screws lie under the battery board data cable. You may need to gently maneuver the cable from side to side to access each screw.

  • Either screw may have a water damage indicator sticker on the top. If so, remove it with a pair of tweezers and set it aside before removing the screw.

Gebruik een T5 Torx-schroevendraaier om de twee 3.1 mm schroeven, die het batterijbord bevestigen, te verwijderen.

Deze schroeven zitten onder de datakabel van het batterijbord. Het kan zijn dat je de kabel van de ene naar de andere kant moet verplaatsen om bij alle schroeven te kunnen.

Beide schroeven kunnen een waterschade-indicatorsticker bevatten. In dat geval kun je deze met een pincet verwijderen en wegleggen voordat je de schroeven verwijdert.

[title] Remove the battery
[* red] Use a T5 Torx driver to remove the two 3.1 mm screws securing the battery board.
[* icon_note] These screws lie under the battery board data cable. You may need to gently maneuver the cable from side to side to access each screw.
- [* icon_note] Either screw may have a water damage indicator sticker on the top. If so, remove it with a pair of tweezers and set it aside before removing the screw.
+ [* icon_note] Either screw may have a water damage indicator sticker on the top. If so, remove it with a pair of [product|IF145-020|tweezers] and set it aside before removing the screw.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.