Repareer je spullen Gemeenschap Winkel

Wijzigingen aan stap #13

Bewerken voor Jeff Suovanen —

Bewerking goedgekeurd door Jeff Suovanen

Voor
Na
Ongewijzigd

Stap regels

-[* black] Next out: the midframe that housed the motherboard, accompanied by the small ribbon cable and the attached headset button.
-[* black] A closer look at the midframe reveals a slot for the little black nub on the rear of the display panel.
- [* icon_note] This slot allows the nub to peek through and slide along that white Teflon strip. This ''looks'' like a linear [https://en.wikipedia.org/wiki/Potentiometer|potentiometer], which could be used to track IPD position as you adjust the displays.
-[* black] Ready to go deeper, we remove a smaller midframe and peel away the rubber light-gasket from around the lenses.
+[* black] Next out: the midframe that housed the motherboard. Clinging to its side we find a small ribbon cable that plays host to the headset button.
+[* black] A closer look at the midframe reveals a slot for the little black nub on the back of the left display panel.
+ [* icon_note] This slot allows the nub to peek through and slide along that white Teflon strip, activating what ''looks'' like a linear [https://en.wikipedia.org/wiki/Potentiometer|potentiometer]—likely used to track IPD position as you adjust the displays.
+[* black] Ready to go deeper, we remove the twin lens-and-display assemblies from thier housing, and peel off the rubber light-gasket from around the lenses.