Inleiding
This guide involves taking apart the Zoomer Dino Boomer in order to disconnect the sensor button from the main circuit board for replacement.
Wat je nodig hebt
-
-
Turn dinosaur over and hold upright.
-
Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.
-
-
-
Gereedschap gebruikt in deze stap:Tweezers$4.99
-
Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers.
-
Remove back cover.
-
-
-
Where the button is largest, squeeze the two white tabs together.
-
-
-
Push in the white circular piece between these tabs as far as it will go.
-
-
-
Where the button is smallest, squeeze the two white tabs together and press the circular tab in-between them until the button comes loose.
-
Remove the back button.
-
Vraag FixBot
To reassemble your device, follow these instructions in reverse order.
Team
USF Tampa, Team 16-1, Wollert Fall 2015 Lid van USF Tampa, Team 16-1, Wollert Fall 2015
USFT-WOLLERT-F15S16G1
3 Leden
10 handleidingen geschreven
