Inleiding

The WowWee MiP robot has a tendency towards short battery life. If the MiP seems too slow or stops responding, use this guide to change the MiP’s batteries. The MiP’s batteries are located in a battery pack on the robot's back.

  1. Remove the three 12.0 mm Phillips # 2 screws from the battery cover.
    • Remove the three 12.0 mm Phillips # 2 screws from the battery cover.

  2. Carefully pull the battery pack from the robot.
    • Carefully pull the battery pack from the robot.

    • Remove the batteries from the battery pack.

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Moira Keahon

Lid sinds: 24-09-14

166 Reputatie

3 handleidingen geschreven

Team

University of Maine, Team 1-50, Diaz Fall 2014 Lid van University of Maine, Team 1-50, Diaz Fall 2014

UMAINE-DIAZ-F14S1G50

3 Leden

3 handleidingen geschreven

Its a programmer MIP not this kind.

Azariah Trumble - Antwoord

Same question here, instructions needed for CODER MIP as it doesn't seem to be a holding a charge.

Gil Acosta - Antwoord

does spare battery adapter vailable(not reachargeable)

coolboyz' channel - Antwoord

Coder Mip Battery says fully charged - but Coder Mip doesnt turn on?

Sadie - Antwoord

Coder MiP one day old - was working - battery says fully charged - but Coder MiP doesn’t turn on? Any suggestions?

Sadie - Antwoord

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 23

Afgelopen 30 Dagen: 261

Altijd: 8,539