Inleiding
This is a step by step guide to completely disassemble a Palm Tungsten E.
Wat je nodig hebt
-
-
-
Remove the stylus and SD card.
-
Using a T5 torx screwdriver, remove all 4 back panel screws.
Vraag FixBot
-
-
-
Insert a plastic opening tool under the USB and power input slots.
-
Slide the plastic opener along the seam and gently pry the cover from the PDA body to remove the cover completely.
-
-
-
-
Remove the screen protector by lifting the hinge out of the plastic housing.
-
Remove the top cover by gently pulling it away from the device with a plastic opening tool or your fingers.
-
-
-
Carefully remove motherboard from the standoffs without damaging the LCD flex connector.
-
Using a spudger, unlock both sides of the flex connector block by pushing down.
-
Remove motherboard completely.
-
-
-
Remove buttons using fingers.
-
Gently flex frame to release screen from plastic frame.
-
Lift out screen.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 13-22, Maness Winter 2010 Lid van Cal Poly, Team 13-22, Maness Winter 2010
CPSU-MANESS-W10S13G22
4 Leden
8 handleidingen geschreven
