Onderdelen

Geen onderdelen nodig.

  1. Slide the battery latch down the side of the camera with your hands.
    • Slide the battery latch down the side of the camera with your hands.

    • The latch will automatically pop open.

    Voeg opmerking toe

  2. Unlatch the clip over the battery.
    • Unlatch the clip over the battery.

    • The battery will partially pop out.

    Voeg opmerking toe

    • Remove the battery from the camera.

    Voeg opmerking toe

    • Remove the four 3.0mm Phillips #000 screws on the top of the camera with the phillips screwdriver.

    • Remove the additional four 3.0mm Phillips #000 screws on the bottom of the camera.

    Voeg opmerking toe

    • Once the screws are removed, slowly remove the back casing from the rest of the camera.

    Voeg opmerking toe

    • Then, pull the front case away from the rest of the camera.

    Voeg opmerking toe

    • After the casing is removed, the camera should look as shown.

    Voeg opmerking toe

    • Remove the 3.0mm Phillips #000 screw above the battery door on the side of the camera.

    Voeg opmerking toe

    • Pull off the pieces of casing located on either side of the top button of the camera.

    • Both of the two pieces should slide off very easily. Do not force them off.

    Voeg opmerking toe

    • Remove the top button piece. You will need to detach a small blue ribbon cable before the button can be fully removed.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Andrew Forster

Lid sinds: 16-04-12

9 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 17-25, Amido Spring 2012 Lid van Cal Poly, Team 17-25, Amido Spring 2012

CPSU-AMIDO-S12S17G25

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 596