Inleiding
This guide will show how to replace a motherboard. The motherboard could be causing faulty display, not turning on, and bad sound quality on a continuous basis.
Before any repair work can be done, one must remove the device from the vehicle. To do so follow this link to see a vehicle general removal of a stereo system.
Wat je nodig hebt
-
-
-
Remove two 4.9mm Phillips #00screws on the front of the device.
-
Remove two 7.5mm Phillips #00screws on the front of the device.
-
-
-
Rotate device 90 degrees to either side.
-
Use the plastic opening tool to pry open the top and bottom tab respectively.
-
Repeat on opposite side.
-
-
-
-
Press down on the clip like you would an Ethernet cable.
-
Rock harness side to side, pulling gently towards you until harness detaches.
-
-
-
-
-
Remove four 9.5mm Phillips #00 (black) screws from back panel.
-
Remove two 7.5mm Phillips #00 (black) screws from back panel.
-
-
-
-
Remove one 9.5mm Phillips #00 screw.
-
Rotate device 180 degrees and repeat step.
-
-
-
Using plastic opening tool, detach the tabs. There are two on either side.
-
-
-
Vraag FixBot
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
4 andere personen hebben deze handleiding voltooid.
Team
USF Tampa, Team 10-2, Brown Fall 2014 Lid van USF Tampa, Team 10-2, Brown Fall 2014
USFT-BROWN-F14S10G2
3 Leden
7 handleidingen geschreven
