Inleiding
This guide will show you how to remove/replace the bumper plate assembly on your Shark Matrix RV2310. This is most useful in scenarios where your vacuum's bumper assembly has been cracked or broken, leaving the sensor components underneath vulnerable.
Wat je nodig hebt
-
-
-
Remove the six 8 mm hex screws that are holding both pieces of the bumper plate together.
Vraag FixBot
-
-
-
-
Separate both pieces of the plate from one another by pulling them apart.
-
Pull the full bumper plate assembly away from the vacuum.
-
-
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
Één andere persoon heeft deze handleiding voltooid.
Team
UMass Dartmouth, Team 6-4, Botvin Spring 2024 Lid van UMass Dartmouth, Team 6-4, Botvin Spring 2024
UMASSD-BOTVIN-S24S6G4
2 Leden
11 handleidingen geschreven
