Ryobi CSB135L Power Cord Replacement

Inleiding

This guide will show you how to properly replace the power cord in the Ryobi CSB135L. If the symptoms in our troubleshooting page for a damaged power cord align with the symptoms your Ryobi CSB135L are experiencing your power cord is most likely damaged.

Wat je nodig hebt

Stap 1 Power Cord

Ryobi CSB135L Power Cord Replacement, Power Cord: stap 1, afbeelding 1 van 1

Place the saw on a flat surface.
Make sure the saw is unplugged and unpowered.

Bewerken

Stap 2

Remove the six M4x16mm Phillips screws and the two M4.5x35mm screws using a Phillips #2 screwdriver.
Remove the front facing half of the handle assembly exposing the internals of the saw.

Bewerken

Stap 3

After removing the handle assembly locate the trigger switch and wire nut in the saw.
Remove the screw from the black wire of the power cord using a Phillips screwdriver. Then remove the wire.
Loosen the wire nut and remove the neutral wire from the power cord.

Bewerken

Stap 4

Remove the power cord from the saw.
To insert the replacement power cord, insert the black wire of the cord into the trigger switch and tighten the screw. Take the neutral/white wire of the new cord and insert it into the wire nut and tighten the nut.
Wire strippers may be needed when installing the new power cord to expose the copper wire.