Ga door naar hoofdinhoud

Retro-Bit Retro Duo Circuit Board Replacement

Wat je nodig hebt

  1. Retro-Bit Retro Duo Circuit Board Replacement, Circuit Board: stap 1, afbeelding 1 van 3 Retro-Bit Retro Duo Circuit Board Replacement, Circuit Board: stap 1, afbeelding 2 van 3 Retro-Bit Retro Duo Circuit Board Replacement, Circuit Board: stap 1, afbeelding 3 van 3
    • With the console on its top, remove the four 12 mm Phillips #2 screws.

    • There may be a sticker covering one or more of the screws. Simply remove the sticker before screw removal.

    • Flip the console on its feet. Carefully lift the top casing from the back (where the AV/S and power ports are).

    • To avoid damage, do not remove the top casing completely. There is a small LED circuit board connected to the main circuit board.

  2. Retro-Bit Retro Duo Circuit Board Replacement: stap 2, afbeelding 1 van 3 Retro-Bit Retro Duo Circuit Board Replacement: stap 2, afbeelding 2 van 3 Retro-Bit Retro Duo Circuit Board Replacement: stap 2, afbeelding 3 van 3
    • Remove the one 6 mm Phillips #0 LED circuit board screw.

    • Lift the top case and set aside.

  3. Retro-Bit Retro Duo Circuit Board Replacement: stap 3, afbeelding 1 van 3 Retro-Bit Retro Duo Circuit Board Replacement: stap 3, afbeelding 2 van 3 Retro-Bit Retro Duo Circuit Board Replacement: stap 3, afbeelding 3 van 3
    • Remove the 11 screws holding the circuit boards and ports in place.

    • Six 11 mm Phillips #2 holding the circuit boards.

    • Three 12 mm Phillips #2 screws holding the controller ports.

    • Two 7 mm Philllips #2 screws holding the back ports

  4. Retro-Bit Retro Duo Circuit Board Replacement: stap 4, afbeelding 1 van 3 Retro-Bit Retro Duo Circuit Board Replacement: stap 4, afbeelding 2 van 3 Retro-Bit Retro Duo Circuit Board Replacement: stap 4, afbeelding 3 van 3
    • Carefully lift the circuit board while holding either the AV or controller ports. Alternatively, you can hold the circuit board on its edges.

    • Make sure to lift the circuit board completely out of the bottom case.

    • To avoid damage, do not to touch the top or bottom faces of the circuit board.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Truong Vo

Lid sinds: 09/25/17

320 Reputatie

3 handleidingen geschreven

Team

USF Tampa, Team S4-G4, Eyestone Fall 2017 Lid van USF Tampa, Team S4-G4, Eyestone Fall 2017

USFT-EYESTONE-F17S4G4

3 Leden

10 handleidingen geschreven

Één opmerking

I hope you show the second part were you replace the 72pin connector. Please include part source.

The 72 pin connector grabs too tightly on the cart.

Thanks.

George Tedrick - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 6

Afgelopen 30 dagen: 32

Altijd: 2,432