Inleiding

Before starting this guide you may need some experience with soldering/ desoldering. If you do not know how, you can learn by clicking the link on step 5 (when you have to desolder the aluminum tabs).

Before disassembling your Atari Lynx, be sure the device is powered off.
  • Before disassembling your Atari Lynx, be sure the device is powered off.

  • Remove any game in the console by opening the right latch and sliding the game to the right.

Voeg opmerking toe

Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.
  • Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.

  • Pinch the rear panel with your fingers and lift away from the Atari.

Voeg opmerking toe

  • Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.

  • Be sure not to tear any wires attached to battery panel.

Voeg opmerking toe

  • Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.

  • Be sure not to tear the speaker wire while removing the control panel.

Voeg opmerking toe

  • Desolder the four aluminum tabs and for more information on soldering click here.

Voeg opmerking toe

  • Remove the aluminum back protector to gain access to the C10 capacitor.

Voeg opmerking toe

  • Desolder the C10 capacitor.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

John Lopez

Lid sinds: 27-01-14

440 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 1-42, Maness Winter 2014 Lid van Cal Poly, Team 1-42, Maness Winter 2014

CPSU-MANESS-W14S1G42

5 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 10

Afgelopen 30 Dagen: 33

Altijd: 2,682