Inleiding

This guide will instruct on how to replace a malfunctioning Viewfinder assembly on the RCA CC310.

Onderdelen

Geen onderdelen nodig.

Slide a spudger between the plastic rail and the metal tab on the left side of the rail.  Push away from the camcorder to release the flap. Pushing the viewfinder assembly to the right makes lifting the flap easier.
  • Slide a spudger between the plastic rail and the metal tab on the left side of the rail. Push away from the camcorder to release the flap.

  • Pushing the viewfinder assembly to the right makes lifting the flap easier.

  • Slide the lifted flap towards the viewfinder assembly until the viewfinder is free from the rail.

Voeg opmerking toe

Unscrew the 7mm ph#0 screw on the underside where the cable connects. Lift the plastic where the cable connects off of the viewfinder assembly. Disconnect the cable inside by pulling it apart.
  • Unscrew the 7mm ph#0 screw on the underside where the cable connects.

  • Lift the plastic where the cable connects off of the viewfinder assembly.

  • Disconnect the cable inside by pulling it apart.

Voeg opmerking toe

Unscrew two 7.0mm ph#0 screws on the underside of the viewfinder assembly. Lift the viewfinder plastic assembly up and remove.
  • Unscrew two 7.0mm ph#0 screws on the underside of the viewfinder assembly.

  • Lift the viewfinder plastic assembly up and remove.

Voeg opmerking toe

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Flip back the viewfinder access tab.
  • Flip back the viewfinder access tab.

  • Unscrew the 7.0mm ph #0 screw next to the mirror.

Voeg opmerking toe

Lift off both sides of the plastic assembly. When reassembling, if the housing doesn't connect properly, try turning the focus wheel. When reassembling, if the housing doesn't connect properly, try turning the focus wheel.
  • Lift off both sides of the plastic assembly.

  • When reassembling, if the housing doesn't connect properly, try turning the focus wheel.

Voeg opmerking toe

Lift the microphone circuit board straight up. Unclip the cable connected to the circuit board.
  • Lift the microphone circuit board straight up.

  • Unclip the cable connected to the circuit board.

Voeg opmerking toe

Lift plastic housing and guide the wires from underneath. Lift out the entire circuit board and viewfinder. Replace entire circuit board and viewfinder assembly.
  • Lift plastic housing and guide the wires from underneath.

  • Lift out the entire circuit board and viewfinder.

  • Replace entire circuit board and viewfinder assembly.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Oliver Adams

Lid sinds: 19-01-11

620 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 5-20, Amido Winter 2011 Lid van Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 3

Altijd: 1,649