Protocol Vento Motor Replacement

Word lid van de reparatiegemeenschap - Account aanmaken

Inleiding

The Protocol Vento drone has four motors. Each motor is located at the base of one of the drone's four arms. This guide will demonstrate how to remove and replace a motor.

Wat je nodig hebt

Stap 1 Battery

Protocol Vento Motor Replacement, Battery: stap 1, afbeelding 1 van 1

Grasp the tail end of the drone where the lip of the battery protrudes.

Vertaal

Vraag FixBot

Stap 2

Pull away from the drone to remove the battery.
Do not attempt any repairs or replacements before removing the battery from the drone.

Vertaal

Vraag FixBot

Stap 3 Propeller

Protocol Vento Motor Replacement, Propeller: stap 3, afbeelding 1 van 1

Place a prying tool under the base of the propeller.

Vertaal

Vraag FixBot

Stap 4

Use a moderate amount of force to pry the propeller out of its base. The propeller should pop off.

Vertaal

Vraag FixBot

Stap 5 Motor

Protocol Vento Motor Replacement, Motor: stap 5, afbeelding 1 van 1

Unscrew the 4.9mm Phillips #000 screw that is located at the end of the drone's arm.

Vertaal

Vraag FixBot

Stap 6

Hold the base of the arm while gently pulling the motor cover away from the arm.
Do not pull too hard because there are wires attaching the motor to the drone. Do not sever the wires.

Vertaal

Vraag FixBot

Stap 7

Gently pull the motor out from the plastic cover.
Do not squeeze or pull too hard, as to not damage the motor connection.

Vertaal

Vraag FixBot

Stap 8

Gereedschap gebruikt in deze stap:

Tweezers

$4.99

Koop

The motor’s blue and red wires are secured via a white clip. This clip is inserted into a slot in the drone’s leg.
Grasp the clip’s edges with a pair of tweezers and pull outward.
Do not pull directly on the wires, as to not separate the wires from the clip.