Ga door naar hoofdinhoud

Philips DC320 37 Connector Replacement

Wat je nodig hebt

  1. Philips DC320 37 Connector Replacement, Docking entertainment system: stap 1, afbeelding 1 van 1
    • Pry off the four white feet with the pointed end of the spudger

  2. Philips DC320 37 Connector Replacement: stap 2, afbeelding 1 van 1
    • Gently unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

  3. Philips DC320 37 Connector Replacement: stap 3, afbeelding 1 van 1
    • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

    • The connectors on the panel are fragile and may break.

  4. Philips DC320 37 Connector Replacement: stap 4, afbeelding 1 van 3 Philips DC320 37 Connector Replacement: stap 4, afbeelding 2 van 3 Philips DC320 37 Connector Replacement: stap 4, afbeelding 3 van 3
    • Carefully pull up and out the four electrical connectors and two ribbon connectors that connect the bottom panel to the dock.

    • Electrical Connectors

    • Ribbon Connectors

    • The cables do not have a lot of slack in them. Be careful not to break the connectors.

    • One wire is soldered onto the bottom panel. Be careful not to break this bond.

  5. Philips DC320 37 Connector Replacement, Connector: stap 5, afbeelding 1 van 1
    • Pull the copper plate out of the way of the two Phillips #00 screws in the middle of the connector.

  6. Philips DC320 37 Connector Replacement: stap 6, afbeelding 1 van 1
    • Unscrew the two 7 mm Phillips #00 screws holding the connector together.

    • Unscrew the four 5 mm Phillips #00 screws holding the connector to the dock

  7. Philips DC320 37 Connector Replacement: stap 7, afbeelding 1 van 3 Philips DC320 37 Connector Replacement: stap 7, afbeelding 2 van 3 Philips DC320 37 Connector Replacement: stap 7, afbeelding 3 van 3
    • Turn the dock so that you are looking at the front of the dock.

    • Pull out the black U-shaped piece.

    • Pull out the iPhone/iPod support cradle.

    • Pull out the two springs.

  8. Philips DC320 37 Connector Replacement: stap 8, afbeelding 1 van 1
    • Turn the dock so that you are looking at the bottom of the dock.

    • Pop out the black connector frame and attached circuit board from the body of the dock.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Greg Lane

Lid sinds: 04/16/13

39 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 3-48, Amido Spring 2013 Lid van Cal Poly, Team 3-48, Amido Spring 2013

CPSU-AMIDO-S13S3G48

4 Leden

6 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 2

Altijd: 1,226