Inleiding
Use this guide to replace the rear case of the Pentax Optio WG-2.
Wat je nodig hebt
-
-
-
Remove all four 1 mm JIS #00 screws from the back of the camera.
Vraag FixBot
-
-
-
Use your finger to peel the grip off the top of the camera.
-
For best results, start from the right side of the camera, opposite the buttons.
-
-
-
Gereedschap gebruikt in deze stap:Tweezers$4.99
-
Use the tweezers to remove the two buttons from the top of the camera.
-
-
-
Remove the three 1 mm JIS #000 screws from the top.
-
Remove the 1 mm JIS #000 screw from the bottom.
-
-
-
Use the tip of a spudger to flip up the small retaining flaps on the ribbon cable ZIF connectors.
-
Carefully pull the ribbon cables out of their sockets.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
UMass Dartmouth, Team 6-7, Bhusal Spring 2016 Lid van UMass Dartmouth, Team 6-7, Bhusal Spring 2016
UMASSD-BHUSAL-S16S6G7
3 Leden
6 handleidingen geschreven
