Inleiding

Removing the back panel is simple, provided you have the correct screwdriver. Nintendo uses a special Tri-wing bit for the case, be sure you have one of these before disassembling!

  1. Remove the cartridge from the console.
    • Remove the cartridge from the console.

    • Use a Phillips #00 Screwdriver to remove the screw securing the battery door to the rear case, turning the screw counter-clockwise.

    • Remove the battery door.

    Voeg opmerking toe

  2. Use a plastic opening tool or spudger to pry out the battery from the bottom. If a plastic open tool or spudger isn't available, your fingernails may work.
    • Use a plastic opening tool or spudger to pry out the battery from the bottom. If a plastic open tool or spudger isn't available, your fingernails may work.

    Voeg opmerking toe

  3. Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK bij het afrekenen
    Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK
    • Remove the battery from the Nintendo DS.

    Voeg opmerking toe

    • Remove the 7 Y0 screws located on the back.

    • It might be helpful to remove the strap from the hole to access the top left screw.

    Voeg opmerking toe

    • With your hands, pry the back panel off the main case.

    • Separate the back from the front, and set it aside.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

8 andere personen hebben deze handleiding voltooid.

dnguye26

Lid sinds: 28-10-09

313 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 18-3, Maness Fall 2009 Lid van Cal Poly, Team 18-3, Maness Fall 2009

CPSU-MANESS-F09S18G3

4 Leden

11 handleidingen geschreven

Één commentaar

Where do I get a nintendo DS gamepak?

Kayla Maison - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 2

Afgelopen 7 Dagen: 12

Afgelopen 30 Dagen: 44

Altijd: 12,360