Repareer je spullen Gemeenschap Winkel

Newport HT70 Pump Assembly Replacement

Medische apparatuur
Noch iFixit, noch deze reparatiehandleiding worden onderschreven door of zijn gelieerd aan de fabrikant van de desbetreffende medische apparatuur.

Inleiding

If the device’s pump system has not been calibrated, first reference “Pump Leak Calibration” in the device’s Troubleshooting page. Reference this guide for failure of pump-related calibrations and pre-use check.

For more information on replacing the pump assembly, please refer to page 5-20 in the service manual.

Wat je nodig hebt

  1. Newport HT70 Pump Assembly Replacement, Pump Assembly: stap 1, afbeelding 1 van 1

    • Position the base assembly so that you may access it.

    • Using the #1 Phillips screwdriver, unscrew the four screws (SCR3219P in the photo) and the two screws (SCR3232P) securing the base plate.

    Vertaal

  2. Newport HT70 Pump Assembly Replacement: stap 2, afbeelding 1 van 1

    • The base plate will then come apart from the rest of the device with the pump assembly attached to it, as depicted in the following photo.

    • Inspect pump assembly for any damage or looseness.

    Vertaal

  3. Newport HT70 Pump Assembly Replacement: stap 3, afbeelding 1 van 1

    • If damage is found, replace the pump assembly by removing each tube individually and replacing as needed.

    • You may not need to replace the entire assembly if parts of it are still intact.

    Vertaal
Conclusie

To reassemble your device, follow these instructions in reverse order.

Auteur

met 2 andere bijdragers

Merek McGill

Lid sinds: 04/07/20

520 Reputatie

5 handleidingen geschreven

Medailles: 7

+4 andere badges

Team

Cal Poly, Team S7-G5, Paton Spring 2020 Lid van Cal Poly, Team S7-G5, Paton Spring 2020

CPSU-PATON-S20S7G5

3 Leden

6 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 2

Altijd: 195