Inleiding

Is the plastic casing cracked or severely scratched? Replace it.

  1. Using your finger, press down on the clip holding the back cover on.
    • Using your finger, press down on the clip holding the back cover on.

    Voeg opmerking toe

  2. Using the spudger or your finger, gently pull the battery out from the top.
    • Using the spudger or your finger, gently pull the battery out from the top.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Remove the four rubber pieces from the face of the phone using the sharp end of the spudger.

    • The rubber pieces are held in with a mild adhesive.

    Voeg opmerking toe

    • Remove the four Torx-6 screws from underneath the rubber pieces.

    Voeg opmerking toe

    • Close the phone before proceeding.

    • Using the flat end of the spudger, insert it under the plastic at the top left of the phone.

    • Gently, although a small amount of force is required, use a twisting motion to pull the plastic casing away from the body of the phone.

    • Continue to move around the phone counter clockwise until the casing is separated from the body.

    • It is not unusual for it to pop off before making it back to the starting point.

    Voeg opmerking toe

    • If the casing has not popped off of the body, remove it carefully from the the phone.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Austin Hobbs

Lid sinds: 21-01-10

30 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 8-50, Regan Winter 2010 Lid van Cal Poly, Team 8-50, Regan Winter 2010

CPSU-REGAN-W10S8G50

3 Leden

14 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,828