Repareer je spullen Gemeenschap Winkel

Lorex LW2742 Lens Replacement

Geschreven door: Alex Kusmierz (en 4 andere bijdragers)
  • Reacties: 0
  • Favorieten: 0

Moeilijkheid

Gemiddeld

Stappen

7

Tijd vereist

5 - 10 minuten

Secties

1

Markeringen

0

Inleiding

Is there a scratch, chip, or crack in your lens causing your image to be blurry? Replacing the lens may solve this problem.

  1. Remove the six 10mm Torx T10 screws on the camera face. Remove the six 10mm Torx T10 screws on the camera face.

    • Remove the six 10mm Torx T10 screws on the camera face.

    Vertaal

  2. Remove the exterior lens cover.

    • Remove the exterior lens cover.

    Vertaal

  3. Remove the foam ring around the lens with tweezers. Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step. Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.

    • Remove the foam ring around the lens with tweezers.

    • Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.

    Vertaal

  5. Remove the two 5mm Phillips #1 screws.

    • Remove the two 5mm Phillips #1 screws.

    • Remove the two 8mm Phillips #0 screws.

    • When reassembling, tighten the top and bottom 5mm screws first, followed by the left and right 8mm screws.

    Vertaal

  6. Remove the LED board with tweezers.

    • Remove the LED board with tweezers.

    • It is unnecessary to unplug the LED board from internal components for lens replacement.

    Vertaal

  7. Use the Phillips #000 to remove the three 3mm screws on the face of the camera lens Use the Phillips #000 to remove the three 3mm screws on the face of the camera lens

    • Use the Phillips #000 to remove the three 3mm screws on the face of the camera lens

    Vertaal

  8. Remove the camera lens.

    • Remove the camera lens.

    • After replacing camera lens and before reassembly it is encouraged to clean new lens surface with a microfiber lens cleaning cloth

    Vertaal
Conclusie

To reassemble your device, follow these instructions in reverse order.

Auteur

met 4 andere bijdragers

Alex Kusmierz

Lid sinds: 26-09-16

601 Reputatie

5 handleidingen geschreven

Badges: 13

+10 andere badges

Team

USF Tampa, Team 16-1, Eyestone Fall 2016 Lid van USF Tampa, Team 16-1, Eyestone Fall 2016

USFT-EYESTONE-F16S16G1

4 Leden

12 handleidingen geschreven

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 10

Altijd: 679